BRANI 90

  • Increase font size
  • Default font size
  • Decrease font size
Home
CHARACTERISTICS AND TECHNICAL DATA:

- Type: homogeneous grain mass;
- Colour: under catalogue;
- Volume weight: approximately 1.7 kg/l;
- Resistance of steam permeability: µ = 70;
- Min. temperature of layer forming: +5° C;
- Not to be applied under direct sun light;
- Rain resistance: after 16 hours;
- Tensile strength of cohesion with concrete after 7 days: 1.65 MPa

APPLYING AND PROCESSING INSTRUCTIONS:

The application of the “Unitub” silicone plaster can start 24 hours after “Unigrund” ground coat application. When applying on larger surfaces, mix the contents of 2-3 buckets of “Unitub”” plaster in a larger container.
With the option “scratched surface” the applied material is structured with plastic mortar-board till getting the desired effect.
No unfinished surfaces should be left when stopping work. When implementing elements in various colours put paper sticking plaster, and be careful not to smudge the ready plaster with another colour.

CONSUMPTION RATE:

Dragged structure:                            Scratched structure:
- fine appr. 2,5 kg                   - fine appr. 3,0 kg
- medium appr. 2,9 kg           - medium appr. 4,0 kg
- grainy appr. 3,6 kg   
- coarse appr. 4,3 kg
“Unigrund” ground coat appr. 0,15 l.
*The consumption rates depend on the base for 1 sq.m.

WORK INSTRUMENTS:

- electrical boring machine and stirrer;
- plastic mortar-board;
- brush

PREPARATION OF THE SURFACE:

The base should be dry, firm,without greasy stains, dust or cracks.
The surfaces should be even, without holes. If necessary, separate relief façade elements should be applied with rough coating.
In case of repairing of facade surfaces remove the unstable sections, and wash the old paint remainders and grease stains. The repaired sections should have the same sturdiness and bearing capacity with the old surface before the ground coat application. In case of high temperatures and respectively high water absorbing capacity, the latter should be wetted before plaster application.

WEATHER CONDITIONS FOR APPLYING:

The minimum temperature of the air and the base should not be lower than +5° C and higher than +30° C. Do not apply when raining , or direct sunlight and strong wind.
FORM DELIVERY:
Plaster: paste like, in plastic buckets of 25 kg.
Ground coat: liquid, with the colour of the plaster in plastic buckets of 25 kg, 5 kg
 
STORAGE:
 
In well sealed pack. Keep in a cool place with no danger of freezing.